Catalytic combustion equipment this how choose and buy? Note of choose and buy of equipment of _ catalytic combustion

At present on the market can adsorptive cannot equipment of flaming false catalytic combustion is very much, catalysis explodes not successfully even. This kind of product just imitates catalytic combustion highly on the exterior, internal composition sells at a discount greatly. Sham product can bring about catalytic temperature to achieve directly, cannot catalysis, the effect is to buy a case of big activated carbon adsorption only. Catalytic combustion equipment must provide a powerful person or family of alone heat exchanger, heat-insulation layer, pneumatic, lie between explode probe of a powerful person, temperature, nitrogen the equipment of form a complete set such as measure of flame retardant, fire control.

Want to decide according to handling the temperature of waste gas commonly, because different temperature can have different material choice. For instance high temperature off-gas treatment, the proposal chooses equipment of catalytic combustion of 304 stainless steel, because abandon air temperature and attribute,can be opposite equipment generation chemistry reacts and corrode.

Contrary, if the waste gas temperature after processing is not high, to life or budget slightly low, need is acid-proof alkaline off-gas treatment, the proposal chooses 201 material, the price slightly under 304 stainless steel, sexual price is compared opposite better, it is the substitute; of 304 stainless steel

The appearance of activator active and activator carrier affects catalytic combustion directly purify efficiency. Accordingly, when the choice, should consider the figure of activator active and activator carrier, purify efficiency greatly in order to achieve.

Because end air temperature spends can constant change, if activator cannot get used to temperature change, active can drop, meet even burst wears away, because this is needed,the choice can get used to the activator that temperature changes.

Activator price is high, answer to choose the activator with long life as far as possible.

If the company is right budgetary demand is higher, and belong to temporarily transitional devoted, the proposal chooses the catalytic combustion equipment that material of plating zine plate makes, relative value is far under equipment of catalytic combustion of 304 stainless steel and equipment of 201 catalytic combustion, performance is a bit poor. Its are main the reason is his difference of raw material cost is bigger, and artificial finished cost and time cost.

Additional, want to notice the ply of plank. Catalytic combustion equipment is made after finishing, if be in,the setting such as use forklift feels the weight of this equipment is light apparently in the process, basically can judge this manufacturer to pledge go up and is very good control on material qualitative ply in material.