Manufacturer of dust purifying device and everybody share the correct installation measure of pulse hop-pocket dust catcher

Pulse hop-pocket dust catcher serves as at present one kind uses purifying device of frequency rife dust, production manufacturer of very much to it industry is buying it the correct installation step that it often does not know after going back, accordingly weManufacturer of dust purifying deviceSmall make up introduce for everybody with respect to preparation, if everybody is interested in measure, the correct installation of pulse hop-pocket dust catcher can understand.

The content belowManufacturer of dust purifying deviceSmall write the correct installation measure that introduces device of dust catcher of pulse hop-pocket type for everybody:

1, the hoisting of pulse hop-pocket dust catcher should notice to prevent to be out of shape, when equipment leaves factory, to crucial part all solder has hanger, undertake hoisting with hanger please.

2, after the installation such as a place with a draught of room of casing of pulse hop-pocket dust catcher, bag, pass in and out, ash bucket, all connection place should assure airtight not flat, the requirement solders sealed, must execute airtight solder, use fastener connection, must add gaskets, screw all fastener. To place of local air leak, applied silica gel or epoxy resin have rain of shot-off of loss. The sealed stand or fall of hop-pocket dust catcher is the influence runs the main factor with life normally, rate of air leak of requirement of dust catcher of hop-pocket of gas box pulse is less than 3% .

3, when assembling gas district part, advocate tracheal already had made respectively inside the factory, the spot wants to assemble only, control is tracheal (receive air cylinder of promotion a powerful person) want the spot to undertake falling expecting, set buckle wait for installation, the requirement must clear clean inside all pipeline, matter of extremelying He Za exists, all connect all answer fill is sealed material, press via trying not flat.

4, installing bag basket and filter bag is the caution in full installation and careful work, because this should be put at the back to undertake installing, when installation, filter bag must not delimit with collision of pointed good thing, hook, even if small nick, also can make remove dust the life of filter bag shortens greatly. The method that installs filter bag is will remove dust first hop-pocket is spent by casing bag of room is put in board aperture, hold the bedspring pen of bag mouth upside next sunken model, put into the beautiful orifice plate of casing, make bedspring circle recovers from an illness again, make its close together ground impaction is on Hua Kongyuan week, insert bag basket gently from bag mouth next, till till bag basket the protecting cover of upside is pressed inside casing to spend board aperture to go up really. Walk bad to prevent filter bag, ask every had held bag of a filter, install to remove dust framework. Filter bag, remove dust bag basket and the installation that spend orifice plate.

5, after bag basket has been installed, install pressing plate even, so that make filter bag the ground wire that go up, bag basket, beautiful board 3 person close together contact. The explosion proof door on pulse hop-pocket dust catcher, before leaving factory when mix up is installed, had not needed to be moved again.

Above content is usManufacturer of dust purifying deviceSmall make up the pulse hop-pocket dust catcher that shares for everybody to install measure correctly, hope to be able to be helped somewhat to everybody, if everybody still thinks understanding is more,about the relevant data of dust purifying device everybody can pay close attention to our official website.